08-03-2014, 08:45 PM
A long flat blade screwdriver down through the top hole will pop the rubber pad loose, albeit further down the tube. Since its smaller that the tube anyway, it will flush out when you dump, so I would worry about it.
The lower plastic piece should come out, but you may need to soak it loose first. I would probably try some clr or the like. Let it soak for an hour or so, then push on one end with the same long screwdriver. It hopefully will pop loose and curl up on the other side.
I haven't looked in a while, but I thought you could buy the individual parts to the valve from Stephen Birtles. I know you can get the rubber paddle and plastic holder separately. Those and the rod should get you back together.
Ideally, plumbers grease should be applied to the sealing areas of the rubber paddles annually. It prevents this from occurring, but is often placed low on the repair list.
The lower plastic piece should come out, but you may need to soak it loose first. I would probably try some clr or the like. Let it soak for an hour or so, then push on one end with the same long screwdriver. It hopefully will pop loose and curl up on the other side.
I haven't looked in a while, but I thought you could buy the individual parts to the valve from Stephen Birtles. I know you can get the rubber paddle and plastic holder separately. Those and the rod should get you back together.
Ideally, plumbers grease should be applied to the sealing areas of the rubber paddles annually. It prevents this from occurring, but is often placed low on the repair list.
06 M450LXi 3 slide