04-03-2015, 04:48 PM
Jon,
It was the pulley side. I did replace both. The ones at TSC are greasable. When I got home I used 3/8 rod, welded it to the bearing holder to make four spokes, and then welded the spokes to the cage. It looks a lot better than the bolted up arrangement.
If you go the welding route, make sure the shaft is perpendicular to the housing before you get too far.
It was the pulley side. I did replace both. The ones at TSC are greasable. When I got home I used 3/8 rod, welded it to the bearing holder to make four spokes, and then welded the spokes to the cage. It looks a lot better than the bolted up arrangement.
If you go the welding route, make sure the shaft is perpendicular to the housing before you get too far.
Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home
)