[pairodice]

The Freedom 25 is indeed a combination inverter/charger. The manual states that the power switch should be OFF at the unit if the remote panel is used (it is) so I will see what that does if anything.
What started this whole thing was the power going off this morning. We are on 50amp power and have had it go off a few times (just our site).
I went to reset the breaker to see what the amperage draw at the pedestal was (we have a Progressive Systems PT50C EMS on the parks 50 amp pedestal). After resetting the breaker the amperage was right at 50amps. When I went inside I noticed the switch to the charger on the Heart Interface remote panel was on at the same time as our AquaHot 110/240 volt system. It looks like both the inverter/charger are on the same power leg and combined are over 50 amps. Nearly 20 amps when charging the batteries - is this a normal amperage draw for charging? I don't want to have to switch them on/off in order to not overdraw the breaker but is there maybe something either set incorrectly or wrong with the inverter (maybe)?
Amperage Draw (includes 'ghost' amp draws of about 3amps):
-No inverter/charger or electric AH: leg 1: 3amps
-Charger only: leg 1: 21amps
-110/240volt Electric AH only: leg 1: 36amps leg 2: 21amps (wow)
-tile floor heat: leg 2: 7amps
-under sink instant hot water heater: Leg 1: 10amps
-microwave: leg 2: 19amps
-110volt heater in closet: leg: amps
-110volt heater in toilet: leg: amps
-110volt portable heater: