[jcus]

Is a non cooled compressor an option?
Been thinking about this, wish another newell around here so I could look at layout.
Think bellhousing flange is standard, but would have to see oil and air lines and physical
size. [Water cooled may be smaller because no air cooling fins are necessary]
You don't have any pics of your 95 compressor, do you? ha!

Can you temporarily cap the coolant lines to the compressor?
Yes, have bypassed compressor and ran a line between both eng head fittings, but not
so sure compressor would be reliable because it is designed for water cooling.

Was there any warranty on the reman unit?
I believe so, must remove it and deliver to parts place 60 miles away for evaluation.

Is there coolant in the wet tank?
A small amount of water, but not green anti-freeze and dryer is only spitting a little water.