[Chester Stone]

I am going to work on this some today, but I question if there is any problem with the compressor circuit since both compressors draw full amperage when the connecting lines are switched, and just as the high amperage switches between compressors, so does the low amperage. This is not the unit that I had to replace the fan motor, and the low fan issue has existed since I replaced the thermostat, but I was not aware of the low amperage until I tested it recently. I will check to see if the Y1 and Y2 thermostat wires are switched in the control panel, and if so, that would account for the low fan speed working when the compressor wires are switched. Keep giving me your thoughts because I am at a loss to figure this out. I may have to send the control panel off to have it reconditioned again.