[Jackflash]

For the second time now the attachment point at the bottom of the lift mechanism has torn out. The first time it happened I used a piece of furniture grade hardwood plywood to replace the torn out piece but it failed in a couple of years. Has anyone else had this issue? How did you fix it?  I'm thinking of going to an aluminum plate.

Had two different failures on mine, can you post a photo?  One on the retract portion and one on the lift but neither failure sound like what you are describing

Sorry for the delay, been a little busy and haven't had a chance to check the board. My failures were at the bottom attachment to the floor. I have attached a picture of my current fix, I used a combination of plywood and aluminum plate.