You are not logged in or registered. Please login or register to use the full functionality of this board...


Trans won't go into Drive
#2

Check your electrical connections. All of those can be tied to bad connections either at sensors or at the Transmission ECU. The 2511 is no speed reading from the rear output shaft sensor. 5517 deals with the shift solenoid and 5587 indicates that the C3 pressure switch did not close at the end of the shift from Neutral to Reverse.

That is the result of Google assistance, not personal knowledge.

Michael Day
1992 Newell 43.5' #281
NewellOwner.com
Reply


Messages In This Thread
Trans won't go into Drive - by 409Mint - 01-05-2019, 08:35 PM
RE: Trans won't go into Drive - by Fulltiming - 01-05-2019, 09:18 PM
RE: Trans won't go into Drive - by bikestuff - 01-06-2019, 05:22 AM
RE: Trans won't go into Drive - by 409Mint - 01-06-2019, 07:49 AM
RE: Trans won't go into Drive - by ccjohnson - 01-06-2019, 08:20 AM
RE: Trans won't go into Drive - by ashley - 01-06-2019, 11:08 AM
RE: Trans won't go into Drive - by Richard - 01-06-2019, 04:10 PM
RE: Trans won't go into Drive - by 409Mint - 01-15-2019, 09:04 PM
RE: Trans won't go into Drive - by bestgenman - 01-16-2019, 07:08 AM
RE: Trans won't go into Drive - by jimg - 01-16-2019, 08:03 AM
RE: Trans won't go into Drive - by 409Mint - 01-21-2019, 04:09 PM
RE: Trans won't go into Drive - by Richard - 01-21-2019, 04:40 PM
RE: Trans won't go into Drive - by 409Mint - 01-21-2019, 04:54 PM
RE: Trans won't go into Drive - by Richard - 01-25-2019, 06:47 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)