05-21-2019, 10:20 AM
Thanks Richard, that is exactly spot on. Just replaced the sealant on 270 degrees of the slide room tube to exterior skin joint. It was de-bonded on the skin side of the fillet. No rain here for the next 7 days so we will see if that helped.
I replaced the silicone wedges at the corners of the slide tube. Is there a method to form the dab of silicone to the crease, in the inflatable seal without making a mess? Not that I made a mess or anything like that just asking:-)
Thanks
Steve
I replaced the silicone wedges at the corners of the slide tube. Is there a method to form the dab of silicone to the crease, in the inflatable seal without making a mess? Not that I made a mess or anything like that just asking:-)
Thanks
Steve
Steve & Doris Denton
45' Newell #525, Bath & Half
2014 Honda CRV Toad
Summerfield, FL