08-20-2020, 02:33 PM
Hi Richard, I seem to have the same microswitch detail - no magnetic sensors on the top of the slide.
It appears that the failure of the retracted position microswitch is responsible for my locking pins not deploying. Also for the pump not shutting off until one releases the control panel switch. So I have a new switch ordered. My further concern, though, is that the assembly on which the microswitch is mounted seems to be frozen in a position that prevents the microswitch from unmaking the connection when the slide is extended. Attached photo shows the mounting block; is seems that this should float on the end of the guide track so that it rebounds when the slide is extended. If this consistent with your observations?
Thanks!
Chuck
It appears that the failure of the retracted position microswitch is responsible for my locking pins not deploying. Also for the pump not shutting off until one releases the control panel switch. So I have a new switch ordered. My further concern, though, is that the assembly on which the microswitch is mounted seems to be frozen in a position that prevents the microswitch from unmaking the connection when the slide is extended. Attached photo shows the mounting block; is seems that this should float on the end of the guide track so that it rebounds when the slide is extended. If this consistent with your observations?
Thanks!
Chuck
2001 #579 ("Chester's Coach")