You are not logged in or registered. Please login or register to use the full functionality of this board...


Shower tower
#1

Hi everyone,
I am looking for any advice on removing the shower tower.  I need to take the shower tower off to replace a shelf which screws on from the back.  I did see where there are two brackets, top and bottom, which have two set of nuts and bolts on each.  I tried this pm to remove them but appear to need much smaller hands to get to them.  I've attached a couple of images of the tower and the screws I need to get to.


Attached Files Thumbnail(s)
       

Brandi and Chris
Coach #636
Hot Springs Village, AR

Reply
#2

Take off all the escutcheon plates around the handles and shower head. Then pry gently at the edge. I think you will find it is held at the edge with silicone. Go easy the material is brittle.

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#3

That does not look like the original Newell setup.  

I am guessing you will need to figure out how to get the top and bottom brackets off,  then (like Richard said)…there  might be silicone on the sides.

I have attached some pics of what 653 (2003 vintage) looks like.

Bill


Attached Files Thumbnail(s)
           

Bill Johnson
Birmingham, Alabama
Reply
#4

Thanks Richard and Bill,
I checked and the piece is not sealed on the sides with silicon.  Guess i will have to figure out how to get to the brackets if I want it off.  IF it only had another inch of room....
Chris

Brandi and Chris
Coach #636
Hot Springs Village, AR

Reply
#5

Since you have brackets at top AND bottom…my first guess is that the thing slides in and is held by the brackets. Loosen up the bottom ones and see if the bottom will slide forward. It may be that you only have to get the nuts to turn a bit to loosen.

For what its worth.

Bill

Bill Johnson
Birmingham, Alabama
Reply


Forum Jump:


Users browsing this thread: 2 Guest(s)