You are not logged in or registered. Please login or register to use the full functionality of this board...


Bennett shifter
#1

While I was doing some cleaning up under the bus, I pressed against a hose and heard air escaping. There is a line that goes from the aux air tank manifold at the rear of the coach and to the shifter. I am not sure why they have a rubber line tied into the hose. Can I just have a new hose made in one piece and skip the short rubber section? I was thinking braided stainless. There is space behind the shifter module but the only way to remove/install the hose is by removing the shifter from the transmission. I had to cut off one bolt for removal. Either way, I always replace hardware. What is the consensus of going with a one piece hose?


Attached Files Thumbnail(s)
           

--Simon
1993 8v92TA #312
Reply


Messages In This Thread
Bennett shifter - by BusNit - 02-05-2023, 05:26 PM
RE: Bennett shifter - by Jack Houpe - 02-06-2023, 05:02 AM
RE: Bennett shifter - by Tf175 - 02-06-2023, 06:08 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)