Newell Gurus

hey All,
  I t seems that I have no workable sewer host at the moment. I am looking for a 90 deg adapter that will attache to the powered dump valve then turn 90 deg allow for a valterra connector to exit the bottom of the coach.

I've seen and read a few threads, but most of the links are dead. I see a 45 deg one on Dupree's site. And what's the difference between the adapter and the HOSE adapter on their site?

Any hint?

Thanks!

If you have the orig dupree fitting then the 45 attachment will mate to a standard three inch slinky, it is tight and sometimes requires gentle application of a hair dryer to the slinky. Secure with a hose clamp. I have ever found a valterra to dupree adaptor. I have wedged a three inch smooth connector into the dupree id but its sketchy.

Richard,
Which 45 deg one should I buy? The Hose one with the lip or the smooth one?

Thanks!

I use the smooth one

Ordered!
Thanks Rich!

This is my version.
[attachment=8659]
Used a screw-in valtera and removed the threads to the ID dimension of the Dupree fitting.
Glued and added two screws. This one is about ten years old.

Regarding my 1980 classic, Is the original Dupree a 3 1/2 inch male and the current RV standard male output (valterra retail etc)..only 3 inches? I wondered why my output side is too large for any of the ones available in today’s RV marketplace. Does anyone (Dupree) make a 3 1/2 inch to 3 inch adapter? I too had to fashion a rubber boot to make my own transition as a temporary measure. BTW … Mine has a manual gate valve.

Thanks in advance