HWH Salon Slide Seal Replacement

Home > User galleries > pestes > HWH Salon Slide Seal Replacement

Front ram connection119 viewsThe front ram connection is located behind an access panel in the front passenger wheel well. The access panel is riveted in place.

Rear ram connection96 viewsThe rear ram connection is located in the large pass through bay on the passenger side, rear end of the bay. Bolt is 1 1/8".

Slide seal placed around slide and then slide is supported externally100 views

Pull slide out this far124 viewsSlide is pulled out far enough for lock pin holes to clear side of coach

Installing bottom side of new seal122 viewsThe bottom edge is installed first. Note you can see the leather of the rear wall here, which doesn't extend past the aluminum rear side of the slide, so we did not have to remove it. Coach is filthy because we didn't wash it while the seal was blown. You can also see the white powder ejecta on the rear face of the slide where the old seal blew up.

Floor is very close to wall107 viewsHere you can see where the floor is very close to the wall and care must be taken when pushing the new seal into place to prevent damage.

Top of seal is installed118 views

Slide ram disconnected109 viewsHere you can see where the ram is disconnected from the coach and the slide has been pulled out, pulling the ram with it.

Limit switches115 viewsHere you can see the limit switches above the non-pass through bay. This is where the piece of angle iron is bolted on to trigger the limit switch at full extension. Unfortunately I did not get a picture with the angle iron installed.

9 files on 1 page(s)