 Last additions - HWH Salon Slide Seal Replacement
|
Limit switches113 viewsHere you can see the limit switches above the non-pass through bay. This is where the piece of angle iron is bolted on to trigger the limit switch at full extension. Unfortunately I did not get a picture with the angle iron installed.Aug 28, 2018
|
|
Slide ram disconnected107 viewsHere you can see where the ram is disconnected from the coach and the slide has been pulled out, pulling the ram with it.Aug 28, 2018
|
|
Top of seal is installed117 viewsAug 28, 2018
|
|
Floor is very close to wall105 viewsHere you can see where the floor is very close to the wall and care must be taken when pushing the new seal into place to prevent damage.Aug 28, 2018
|
|
Installing bottom side of new seal120 viewsThe bottom edge is installed first. Note you can see the leather of the rear wall here, which doesn't extend past the aluminum rear side of the slide, so we did not have to remove it. Coach is filthy because we didn't wash it while the seal was blown. You can also see the white powder ejecta on the rear face of the slide where the old seal blew up.Aug 28, 2018
|
|
Pull slide out this far122 viewsSlide is pulled out far enough for lock pin holes to clear side of coachAug 28, 2018
|
|
Slide seal placed around slide and then slide is supported externally98 viewsAug 28, 2018
|
|
Front ram connection102 viewsThe front ram connection is located behind an access panel in the front passenger wheel well. The access panel is riveted in place.Aug 28, 2018
|
|
Rear ram connection93 viewsThe rear ram connection is located in the large pass through bay on the passenger side, rear end of the bay. Bolt is 1 1/8".Aug 28, 2018
|
|
|
|
|
|
|
Home
Login
Return to Forum
Album list
Last comments
Most viewed
Top rated
My Favorites
Search