Pull slide out this far123 viewsSlide is pulled out far enough for lock pin holes to clear side of coach
Installing bottom side of new seal121 viewsThe bottom edge is installed first. Note you can see the leather of the rear wall here, which doesn't extend past the aluminum rear side of the slide, so we did not have to remove it. Coach is filthy because we didn't wash it while the seal was blown. You can also see the white powder ejecta on the rear face of the slide where the old seal blew up.
Top of seal is installed118 views
Limit switches114 viewsHere you can see the limit switches above the non-pass through bay. This is where the piece of angle iron is bolted on to trigger the limit switch at full extension. Unfortunately I did not get a picture with the angle iron installed.
Slide ram disconnected108 viewsHere you can see where the ram is disconnected from the coach and the slide has been pulled out, pulling the ram with it.
Floor is very close to wall106 viewsHere you can see where the floor is very close to the wall and care must be taken when pushing the new seal into place to prevent damage.
Front ram connection103 viewsThe front ram connection is located behind an access panel in the front passenger wheel well. The access panel is riveted in place.
Slide seal placed around slide and then slide is supported externally99 views
Rear ram connection94 viewsThe rear ram connection is located in the large pass through bay on the passenger side, rear end of the bay. Bolt is 1 1/8".
Most viewed - HWH Salon Slide Seal Replacement
Home
Login
Return to Forum
Album list
Last uploads
Last comments
Top rated
My Favorites
Search
