You are not logged in or registered. Please login or register to use the full functionality of this board...


Machining the studs
#2

The explanation I received lacked detail and none was offered. I never got an answer why new wheels with the same hole size and type couldn't be used. This would negate the need to do any machining. The wheels were available in 1998, why not now? Just haven't got that answer.

Steve Bare
1999 Newell 2 slide #531
Reply


Messages In This Thread
Machining the studs - by Richard - 03-07-2014, 07:15 PM
RE: Machining the studs - by rheavn - 03-07-2014, 07:40 PM
RE: Machining the studs - by encantotom - 03-07-2014, 09:05 PM
RE: Machining the studs - by Richard - 03-08-2014, 05:03 AM
RE: Machining the studs - by qcj - 03-08-2014, 06:20 AM
RE: Machining the studs - by encantotom - 03-08-2014, 07:16 AM
RE: Machining the studs - by rheavn - 03-08-2014, 07:43 AM
RE: Machining the studs - by encantotom - 03-08-2014, 07:48 AM
RE: Machining the studs - by rheavn - 03-08-2014, 08:25 AM
RE: Machining the studs - by qcj - 03-08-2014, 08:45 AM
RE: Machining the studs - by Richard - 03-08-2014, 04:34 PM
RE: Machining the studs - by encantotom - 03-08-2014, 05:22 PM
RE: Machining the studs - by folivier - 03-08-2014, 07:59 PM
RE: Machining the studs - by Dean Patterson (texas2dean) - 03-18-2014, 06:59 PM
RE: Machining the studs - by encantotom - 03-18-2014, 08:12 PM
RE: Machining the studs - by rheavn - 03-19-2014, 05:45 AM
RE: Machining the studs - by folivier - 03-19-2014, 05:56 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)