02-01-2020, 11:33 AM
Cold and humidity is your enemy. I too have had this problem. I placed a small heater on an extension cord in my air compressor compartment when we were in the single digits. I had the sensor freeze up and break due to Ice expansion. $110 lesson to replace the sensor.
As far as adjusting the pressure, for me its a Siemens controller, I tried to go into my program and lower the Preset pressures, because I think I'm smart enough. I'm not. Clint Eastwood says " a man needs to know his limitations". sometimes I need to be reminded. New lesson, I SCREWED IT UP. I had to send it back to Valid in BC for them to reprogram back to factory specs. No Charge by Valid, but is was 2 weeks of controlling the pressures by hand. Valid Told me that I need the designed pressures for the leveling system. If it wasn't for the leveling system, I could stay at 60 to 70 psi. for the slide seals, toilets and door.
As far as adjusting the pressure, for me its a Siemens controller, I tried to go into my program and lower the Preset pressures, because I think I'm smart enough. I'm not. Clint Eastwood says " a man needs to know his limitations". sometimes I need to be reminded. New lesson, I SCREWED IT UP. I had to send it back to Valid in BC for them to reprogram back to factory specs. No Charge by Valid, but is was 2 weeks of controlling the pressures by hand. Valid Told me that I need the designed pressures for the leveling system. If it wasn't for the leveling system, I could stay at 60 to 70 psi. for the slide seals, toilets and door.
Dave, Karen, w/Buddy and Moose.
06' Newell #784
towing a 06' Featherlite enclosed trailer or
05' Featherlite stacker for toys and tools,
or a 21' F350
w KTM 300, & MTB35' Packard 4 dr convertible
59' Nash Metropolitan
I like engines and wheels
Carpe Diem. Have Fun
Tomorrow is not guaranteed.