You are not logged in or registered. Please login or register to use the full functionality of this board...


sight tube for hydraulic tank in engine compartment
#3

(04-20-2024, 06:57 PM)encantotom Wrote:  hi,  

i was running some wires for my new camera in the rear engine area above the hydraulic tank and must have bumped the 6 inch sight tube on the outside.  it is the original and i am sure is brittle

it is 1/4 od just like a 1/4 inch dot air line.  it uses compression fittings on the clear tube.  it is slowly dripping on the bottom fitting.  

so....it you have replace it what did you use.  i am looking on amazon for it and rigid acrylic tubing is a choice.  

suggestions?

tom

I will have to check mine, plan to drain my system and do some work on it, would be a good time to go ahead and replace that sight tube while I am at it.

Jeff LoGiudice
Temple Terrace, Fl
1984 Bluebird Wanderlodge PT40
1998 Newell 2000 #490
1986 MCI/TMC 102A3 (sold)
Reply


Messages In This Thread

Forum Jump:


Users browsing this thread: 1 Guest(s)