05-12-2024, 06:00 AM
Richard, they could be punched out easily with the right machine. I used some scrap metal, happened to be a piece of a ride height valve. I doubt there is a large market but perhaps the boating industry would make it worthwhile.
Thanks Jack, I'm following your lead on show & tell.
I get concerned when the pump seal doesn't allow the armature to turn. I wiggle it back & forth a little at a time to break it loose, always worried about causing damage to the seal.
Thanks Jack, I'm following your lead on show & tell.
I get concerned when the pump seal doesn't allow the armature to turn. I wiggle it back & forth a little at a time to break it loose, always worried about causing damage to the seal.
Jim
2014 Newell Coach 1482 Mid Entry 45'8" Valid Slides and Valid Levelling