[Latitude 28]

Hello Tyler,
Sorry you're having an issue with the AH....let's go through some voltage checks.  

Before we get started.  On the Beckett Panel in the AH bay....since the fire sequence obviously did not happen like it should we will need to reset the Beckett Control there is a power wire connected with a blue bullet connector (marked with yellow labels) disconnect that wire and reconnect after a few seconds.  you will hear a slight relay click from inside the Beckett controller....that does the reset. Now turn the AH on and during the initial 20 sec start up check for 12vdc on the ignition portion of the terminal strip....see picture and during the same start up move over to the blower motor and check 12vdc on those terminals.  Did you have 12vdc on the ignition?  Did you have 12vdc on the blower motor?  Was the blower motor running?  If yes to all the above then that's good.  

The Beckett mod does the exact same functions as the original AH controller and ignition coil after that everything else is standard AH troubleshooting.   I'll give you a call in a bit.