[B Humberstone]

I just discovered that my salon slide front locking pin mount is bent out at the bottom. Where the mounting plate is welded to the box tubing it has cracked at the bottom and the box tube is distorted. The lock unit is so bent that when extended the little stop plate that the valance mounts to just slides under it, then when the pin extends it misses the receiver hole. When retracted the pin goes into the hole on top of the slide but since it’s angled inwards it pushes the slide in about a half inch at the top
I have read on here that some people have capped the houses and just removed the pin. 
My question is what wiring jumper are needed to keep everything happy.