You are not logged in or registered. Please login or register to use the full functionality of this board...


Dual 30amp to 50amp Service
#14

We are at another site with Dual 30 amp and a 15 amp for the Xantrex charger.  I used 120VAC 8A Leg 2 Gold Heat floor heat last night to keep the temperature at bay.  I have two 120VAC 1000W 8A Cadet Heaters (Newell calls them Teddy Heaters), one on each power leg, in the Kitchen (Galley) which I am using for heat this morning.  I haven't needed hot water so the Diesel AquaHot is off.
.pdf Cadet Heater Owner Guide.pdf Size: 2.75 MB  Downloads: 0
.pdf Cadet Perfectoe Cut Sheet.pdf Size: 203.55 KB  Downloads: 0
.pdf Perfectoe Cadet Heater Owner Guide.pdf Size: 797.99 KB  Downloads: 1
.pdf Cadet Perfectoe Cut Sheet.pdf Size: 203.55 KB  Downloads: 0
.pdf Web-Gold-Heat-Quick-Install-Manual.pdf Size: 546.67 KB  Downloads: 0


Attached Files
.pdf TDR-Instruction-Supplement-Information.pdf Size: 214.62 KB  Downloads: 2

Jim
2014 Newell Coach 1482 Mid Entry 45'8" Valid Slides and Valid Levelling
Reply


Messages In This Thread
Dual 30amp to 50amp Service - by CaptainGizmo - 08-13-2025, 04:38 PM
RE: Dual 30amp to 50amp Service - by Jack Houpe - 08-14-2025, 03:36 AM
RE: Dual 30amp to 50amp Service - by hypoxia - 08-14-2025, 04:40 AM
RE: Dual 30amp to 50amp Service - by folivier - 08-14-2025, 07:21 AM
RE: Dual 30amp to 50amp Service - by CaptainGizmo - 08-14-2025, 09:35 AM
RE: Dual 30amp to 50amp Service - by hypoxia - 08-14-2025, 10:28 AM
RE: Dual 30amp to 50amp Service - by CaptainGizmo - 08-14-2025, 11:54 AM
RE: Dual 30amp to 50amp Service - by hypoxia - 08-14-2025, 01:29 PM
RE: Dual 30amp to 50amp Service - by CaptainGizmo - 08-14-2025, 05:12 PM
RE: Dual 30amp to 50amp Service - by hypoxia - 08-14-2025, 07:36 PM
RE: Dual 30amp to 50amp Service - by CaptainGizmo - 08-14-2025, 09:36 PM
RE: Dual 30amp to 50amp Service - by hypoxia - 08-22-2025, 04:13 AM
RE: Dual 30amp to 50amp Service - by hypoxia - 08-26-2025, 12:41 PM
RE: Dual 30amp to 50amp Service - by hypoxia - 09-04-2025, 05:40 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)