You are not logged in or registered. Please login or register to use the full functionality of this board...


Plumbing Bay 110v heater
#1

Hello. I have a 2000 coach with an electric cube heater on the driver side of the plumbing bay near the Headhunter water pump. It is controlled by a mechanical thermostat on the passenger side of the same bay. it stopped working (no power on outlet)

I thought it was the thermostat so I bought a new mechanical one and when I took out the old one to measure the line voltage I didn't have power in thermostat box. there are two wires...I thought one was incoming hot and the other was going across the bay to the switched outlet. 

I have a 110v breaker in back labelled "compt heater" which was on and I measured and it has voltage on it.

so, what am I missing?

either this is wired in a way I don't understand or I have something broken in a hidden location between the rear ac breaker and the thermostat box

any suggestions?

Thanks,

Don
Reply


Messages In This Thread
Plumbing Bay 110v heater - by [email protected] - 11-12-2025, 04:42 PM
RE: Plumbing Bay 110v heater - by Jack Houpe - 11-13-2025, 05:12 AM
RE: Plumbing Bay 110v heater - by [email protected] - 11-13-2025, 02:24 PM
RE: Plumbing Bay 110v heater - by Jack Houpe - 11-14-2025, 05:14 AM
RE: Plumbing Bay 110v heater - by Richard - 11-14-2025, 10:41 AM
RE: Plumbing Bay 110v heater - by [email protected] - 11-14-2025, 01:36 PM
RE: Plumbing Bay 110v heater - by Richard - 11-14-2025, 05:19 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)