[hbens]

Update on this issue of the floor not raising up.
While at Newell they swapped the connector from the slide out and raise floor solenoids after the slide was out and the floor stayed down. The floor raised up as it should. Therefore the signal to the raise floor solenoid wasn't getting to the solenoid. The computer either thought the slide room had not extended or wasn't passing the raise floor signal to the solenoid.
I added a switch to manually put 12vdc on the raise floor solenoid. After the slide goes out, I flip this switch and use the extend switch in the cockpit to raise the floor. When the floor is raised all the way up I open the switch and turn the room slide key off.
I'm going to have Newell snake a 7 wire cable up from the L1 bay into the drivers compartment. I'll move this switch inside on my schedule later.