[Pluto]

After a month of waiting, we began installation today.  Our new aquahot came in last Friday, but we had an unexpected loss in the family and had to postpone the installation until this weekend.  

We spent all day on it and made some good progress, but got some more to do tomorrow. The two units are pretty much identical but there are a couple small differences. There is a green, a black and a red wire that goes through the case and to a sensor or something above the thermostat switches, however there is no hole in the no unit, so i have to figure that out. 

We filled the unit with about 13 gallons of transfer fluid and have to top it off tomorrow as well as make sure all of the pumps are primed. We also have to get the unit wired, but hopefully we can get it finished up without too many issues.

---

Here is a couple of pictures of the unknown sensor and wiring that I have to figure out.  It's not in the wiring diagram so I'm not sure about it.