01-16-2013, 08:57 PM
(01-14-2013, 05:13 AM)smagown Wrote: Les:
Newell uses 3M VHS double sided tape. Take the molding off and clean both surfaces real good. I used a 3M abrasive wheel on my air grinder for the prep work.
Thanks,
Thanks for all the good tips, fortunatlly I found out my molding si made of aluminum ! so removing is out of qestion since is riveted to teh bay doors.
What i did so far is I put two big clamps on each corner and left them over night see if that will bend back , if not i am sure double tape wont hold in place ( two small holding surface ! only about 3/4 " )
I think liquid nails and clamp than screw on the inside of the bay door is the ticket here!
Les & Cheryl Korcala
Fulltime on the road hub base in Montana
Newell 2001 2 slide #582
security system 2 Rhodesians Ridgebacks (Basha & M'Kala)
Nissan Exterra 2007
Co-Motion "Robusta" tandem
Trek "madone" road bikes
Trek 5.8 MTb