[Jackflash]

I've been parked here in Michigan for about a month, when I got here I leveled up, rested the coach on blocks and released the air form the suspension so that my compressor doesn't run so much.  The jack stand under the right rear sank a couple of inches over time so a I decided to relevel. I raised the entire coach all the way, reset my jack stand and and went to lower the coach onto the blocks.  As the coach dropped I started hearing and unusual amount of creaking and the windshield started leaking(it was raining at the time). I couldn't figure out what was going on until I got out of the coach and noticed that the center piece between the windshield sections was no longer square to the world and the drivers side was higher than the passenger side.  I raised the passenger front corner backup which took the stress off the windshield but now we are way higher in front.  My coach has the "Newell leveling system" it is a panel of 8 rocker switches, one to raise/lower each corner and one for each side, front and back.  I can hear the solenoids click when rocking ea switch up and down except the driver front corner, it clicks when pushed to the raise position but not to the lower position.  I got under the front and found the proper connector and put a voltage meter on it while Dianna actuated the switch, no voltage.  My understanding is that all the circuits are on the same fuse (though I can't find that fuse) so all I can figure is that the switch must be faulty, any ideas?  What would be the best way to drop the front in the mean time?  How do you get to the back of the panel the switches are mounted in to check the switch?