You are not logged in or registered. Please login or register to use the full functionality of this board...


I'm leaning
#2

Yes look at the adjustment of the high side ride height valve. The vertical rod is attached to a boss just on top of the drive axle. The vertical rod attaches to the horizontal rod of the hcv with a rubber “P”. There will be a small hose clamp at the bottom of the “P”. Loosen the hose clamp to move the vertical rod in the “P”. The rear hcv’s control the side to side heights. Move the “P” on the vertical rod in the direction you wnt to move the coach. Retighten the hose clamp when finished.

You have to be under the coach to do this and you are messing with apparatus that controls the coach height. Dont even think about it without proper support for the coach.

Richard and Rhonda Entrekin
99 Newell, 512
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply


Messages In This Thread
I'm leaning - by TJ Clark - 05-14-2022, 02:14 PM
RE: I'm leaning - by Richard - 05-14-2022, 03:36 PM
RE: I'm leaning - by encantotom - 05-14-2022, 05:42 PM
RE: I'm leaning - by TJ Clark - 05-17-2022, 07:41 AM
RE: I'm leaning - by Richard - 05-17-2022, 11:41 AM
RE: I'm leaning - by TJ Clark - 05-17-2022, 12:34 PM
RE: I'm leaning - by 360 - 05-17-2022, 05:23 PM
RE: I'm leaning - by Richard - 05-18-2022, 05:37 AM
RE: I'm leaning - by 360 - 05-18-2022, 11:59 AM
RE: I'm leaning - by TJ Clark - 05-18-2022, 12:22 PM
RE: I'm leaning - by TJ Clark - 05-02-2023, 05:24 PM
RE: I'm leaning - by TJ Clark - 05-10-2023, 08:57 AM
RE: I'm leaning - by BusNit - 05-10-2023, 10:26 AM
RE: I'm leaning - by Jack Houpe - 05-10-2023, 04:08 PM
RE: I'm leaning - by TJ Clark - 05-10-2023, 05:20 PM
RE: I'm leaning - by Jack Houpe - 05-10-2023, 06:19 PM
RE: I'm leaning - by Richard - 05-11-2023, 04:57 AM
RE: I'm leaning - by Jack Houpe - 05-11-2023, 06:11 AM
RE: I'm leaning - by 360 - 05-11-2023, 06:16 AM
RE: I'm leaning - by Jack Houpe - 05-11-2023, 06:40 AM
RE: I'm leaning - by TJ Clark - 05-11-2023, 08:43 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)