09-22-2022, 09:25 PM
@"arcticdude" - excellent information, thank you!
I'm not sure of the proper term for the covered Valid-Glide-Motor sections; I'll call them "covered motor" --
When you say that the flex-PVC goes between the 90 in the corner and the center -- is it bending to take-up slack inside the covered-motor area? Or is all of this just below the floor?
Thanks again!
I'm not sure of the proper term for the covered Valid-Glide-Motor sections; I'll call them "covered motor" --
When you say that the flex-PVC goes between the 90 in the corner and the center -- is it bending to take-up slack inside the covered-motor area? Or is all of this just below the floor?
Thanks again!