[encantotom]

hi all,

yesterday i hard wired in my vmspc. i drilled a hole in the side of the glove compartment and mounted the control box in there with velcro.

then i ran an extension usb cable from it to under the top of the dash (had to take the dash off) so that it comes out right at where i would use it on my lap top

i ran the connection cable from the vmspc box under the dash using a feed wire over to the plug under the ignition switch. i ohmed out the wires on the plug to make sure i knew which wires did what and connected the wires to the back side of the connector.

so, it is a nice and neat installation and i dont have to have that huge plug plugged in under the dash.

tom