You are not logged in or registered. Please login or register to use the full functionality of this board...


1991 shower hot/cold combiner valve.
#1

I failed to winterize my coach before the cold snap that hit north Texas a couple months ago. The results being a blown water filter, manifold (just replaced with PEX) and the shower head is dripping water eventhough the valve is turned off. Also, the handle refuses to rotate. So my question is, do I need to remove the wall to get to this valve? I'm assuming if so, it's the shower side. Are there hidden screws somewhere or is it all caulking holding it in?


Attached Files Thumbnail(s)
   

- Marcus G-R

8V92TA 43.5' 1991 Newell # 258 
Toad 2015 Mercedes-Benz Gl350 on a BigTex open trailer.  
Reply
#2

You should be able to remove it through a drawer / cabinet space behind that wall. It should be held in place with screws / lag bolts.
Reply
#3

(04-09-2023, 10:24 AM)ccjohnson Wrote:  You should be able to remove it through a drawer / cabinet space behind that wall. It should be held in place with screws / lag bolts.
Thank you for the reply. I found the access panel behind a glued on mirror.


Attached Files Thumbnail(s)
       

- Marcus G-R

8V92TA 43.5' 1991 Newell # 258 
Toad 2015 Mercedes-Benz Gl350 on a BigTex open trailer.  
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)