12-25-2014, 11:55 AM
Paul,
Your pump motor might have quit. First, verify that you are getting 12V to the motor. If you are then the solenoid is good and the motor is your suspect. Pull your slide motor and hook it up to an external 12V source. Motor sits below slide room solenoids and is held in with just two bolts and a battery cable. Removing the motor will not cause an atf leak from reservoir. There are two motor sizes and I was advised to get the larger motor as they both bolt up and the large one is much stronger. Here is a source for a new motor:
The small motor--http://www.elreg.com/dc-motors/dc-motors-complete-units/538-8023-12volt-ccw-hydraulic-pump-motor-250-slot-shaft.html
The large motor--http://www.elreg.com/dc-motors/dc-motors-complete-units/538-6854-12volt-ccw-hydraulic-lift-gate-motor.html
This source is much cheaper than Newell or HWH and motors look exactly the same.
Let us know what you find!
Your pump motor might have quit. First, verify that you are getting 12V to the motor. If you are then the solenoid is good and the motor is your suspect. Pull your slide motor and hook it up to an external 12V source. Motor sits below slide room solenoids and is held in with just two bolts and a battery cable. Removing the motor will not cause an atf leak from reservoir. There are two motor sizes and I was advised to get the larger motor as they both bolt up and the large one is much stronger. Here is a source for a new motor:
The small motor--http://www.elreg.com/dc-motors/dc-motors-complete-units/538-8023-12volt-ccw-hydraulic-pump-motor-250-slot-shaft.html
The large motor--http://www.elreg.com/dc-motors/dc-motors-complete-units/538-6854-12volt-ccw-hydraulic-lift-gate-motor.html
This source is much cheaper than Newell or HWH and motors look exactly the same.
Let us know what you find!
Steve Bare
1999 Newell 2 slide #531