01-20-2015, 06:07 AM
Can you tell exactly where the air leak is by using soapy water or windex?
Can't tell from the picture but it might be one that has a float that dumps water automatically. You could try to remove the canister by pulling down on the black tab at the top and rotating it 1/4 turn counter clockwise. Then clean out the canister with some dawn or simple green, rinse and put some silicone grease on the o-ring before assembling it. That looks like the one I installed on my 120V compressor. The grey connector with red ring at the bottom is to connect a tubing to route the discharge water. I think if you unscrew the black piece above it will release the trapped water. So try to tighten the black part just above the gray connector. That could have come loose.
Can't tell from the picture but it might be one that has a float that dumps water automatically. You could try to remove the canister by pulling down on the black tab at the top and rotating it 1/4 turn counter clockwise. Then clean out the canister with some dawn or simple green, rinse and put some silicone grease on the o-ring before assembling it. That looks like the one I installed on my 120V compressor. The grey connector with red ring at the bottom is to connect a tubing to route the discharge water. I think if you unscrew the black piece above it will release the trapped water. So try to tighten the black part just above the gray connector. That could have come loose.
Forest & Cindy Olivier
1987 log cabin
2011 Roadtrek C210P
PO 1999 Foretravel 36'
1998 Newell 45' #486
1993 Newell 39' #337