You are not logged in or registered. Please login or register to use the full functionality of this board...


Slides
#3

Need some opinions.  We've been in Brownsville, TX for almost a month and a few days ago I noticed a "breeze" when sitting on the couch in the #1 slide (front on drivers side).  In checking on the outside I found the bladder was flat.  The air gage for #1 slide was at "0".  I have a shut-off valve on that valve assembly.  I shut it off and turn it back on and there is a sound of air, but the pressure gage stays at "0".  

I don't know if the air line has come off a nipple or perhaps that vacuum is engaged somehow.  I have taken the line off the bladder side of the valve and air is coming through. If I put my finger up to block the airflow, the gage goes all the way over to the peg, so I know that there is a goodly amount of air going through...BUT...I cannot see and do not know how you get to that nipple or however it's connected.  I have brought the slide in to where the floor drops and can see underneath from inside but the airline just seems to go up into a frame rail and I can't see anything.  

How does one get to that connection?   Any ideas, guys?

Ed & Lynda Perkins
2002 Newell #638 (4 slides)
Tow 2012 TDI VW Jetta Car
2015 Mazda 6 Sedan
1998 F250 Work Truck
Pontoon boat, 2 John Deere Tractors and a golf cart!!!
Reply


Messages In This Thread
Slides - by PlazaGuy - 09-22-2015, 11:29 AM
RE: Slides - by pairodice - 09-22-2015, 01:04 PM
RE: Slides - by PlazaGuy - 02-08-2016, 06:56 AM
RE: Slides - by rheavn - 02-08-2016, 01:47 PM
RE: Slides - by rheavn - 02-22-2016, 04:32 PM
RE: Slides - by PlazaGuy - 02-23-2016, 09:47 AM
RE: Slides - by rheavn - 02-23-2016, 06:37 PM
RE: Slides - by pairodice - 02-24-2016, 05:07 PM
RE: Slides - by encantotom - 02-25-2016, 04:27 PM
RE: Slides - by Chester Stone - 02-26-2016, 08:30 AM
RE: Slides - by folivier - 02-26-2016, 09:05 AM
RE: Slides - by ccjohnson - 02-26-2016, 11:43 AM
RE: Slides - by pairodice - 02-26-2016, 04:09 PM
RE: Slides - by ccjohnson - 02-26-2016, 04:51 PM
RE: Slides - by PlazaGuy - 02-27-2016, 05:41 PM
RE: Slides - by ron skeen - 02-27-2016, 06:21 PM
RE: Slides - by pairodice - 02-28-2016, 01:28 PM
RE: Slides - by ron skeen - 02-28-2016, 02:28 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)