[les korcala]

Les:
Newell uses 3M VHS double sided tape. Take the molding off and clean both surfaces real good. I used a 3M abrasive wheel on my air grinder for the prep work.
Thanks,

Thanks for all the good tips, fortunatlly I found out my molding si made of aluminum ! so removing is out of qestion since is riveted to teh bay doors.
What i did so far is I put two big clamps on each corner and left them over night see if that will bend back , if not i am sure double tape wont hold in place ( two small holding surface ! only about 3/4 " )

I think liquid nails and clamp than screw on the inside of the bay door is the ticket here!