You are not logged in or registered. Please login or register to use the full functionality of this board...


changing both electric elements on aquahot
#7

So I just found out (after finally getting the correct j-box wiring squared away that the, new looking, 220v element is no good. I was trying to put off replacing the 120v one until next spring and only use the 220v one this winter, but nope. Have to replace them so I am going to do both.

I've rigged up a pump/drain system, so that will be painless (mostly) however it appears that there is a shutoff valve on the drain line (NOT the little t-handle one at the end) that is oriented in such a way as to obstruct access to the 220v element. 


Any ideas? Anyone else have this secondary shutoff valve to the drain??

Thanks


Attached Files Thumbnail(s)
   

Be seeing you,

Rick Miller
#423
1996, 45'+, Non-slide, Series 60, ABS, 1.5 Bath, Reverse Floorplan


Reply


Messages In This Thread
changing both electric elements on aquahot - by encantotom - 04-01-2020, 04:43 PM
RE: changing both electric elements on aquahot - by encantotom - 04-01-2020, 04:46 PM
RE: changing both electric elements on aquahot - by Fulltiming - 04-01-2020, 09:02 PM
RE: changing both electric elements on aquahot - by bikestuff - 04-02-2020, 04:57 AM
RE: changing both electric elements on aquahot - by folivier - 04-02-2020, 05:13 AM
RE: changing both electric elements on aquahot - by encantotom - 04-02-2020, 03:44 PM
RE: changing both electric elements on aquahot - by Wanderman - 10-23-2021, 09:26 AM
RE: changing both electric elements on aquahot - by Guy - 10-23-2021, 02:57 PM
RE: changing both electric elements on aquahot - by folivier - 10-23-2021, 03:27 PM
RE: changing both electric elements on aquahot - by Wanderman - 10-23-2021, 04:13 PM
RE: changing both electric elements on aquahot - by Wanderman - 11-07-2021, 04:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)