[Tfrazier]

Hi all,

Getting ready to change out the air dryer. I have spent quite a bit of time looking closely at the current set up and trying to make sure I kind of know what I am doing. This is where my lack of knowledge/skills come shining through and where I need to lean on the expertise of the Gurus.
I have included some pictures that will hopefully help make questions less confusion. The 1st pic is of the current setup and the second one is from the AD-9 installation instructions. Both air dryers have 3 ports. Bendix calls theirs the Control Port, Delivery Port and Supply Port. The Breakmaster ports are Inlet Port, Outlet Port and Unloader Port.
Based on the airline size (1/4") I believe the Control Port and Unloader Ports are the same. My assumption is the Supply Port and Inlet port are the same, which leaves the Delivery Port and Outlet Port to match up. Does that sound right?
Then I'm not sure what to do with the 3/8" airline that T's into the contraption that the Braided Hose is connected to. How would you set this up?
I have also included some pics of the braded hose route. Is the starting point the engine compressor? 
I am probably over thinking this (That tends to be my MO) but this makes me nervous.
Thanks in advance for your help.