[hypoxia]

Has anyone mounted a bidet on a Headhunter Royal Flush?  If so can you report on which one, installation, etc.?

[Richard]

Jim

I have mounted this one on both the Microphor and the Tecma.

https://www.amazon.com/dp/B0026WOUZQ?psc...ct_details


I know it’s not a Headhunter. The point is that in both cases I didn’t use the chrome mounting arm, but instead made a custom mounting plate out of smoked plexi to adapt the bidet to the toilet. I don’t know if that’s a possibility in your situation. But I do know a custom mount is well within your skill sets :-)

[hypoxia]

Thanks Richard. As you know, the difference between the Tecma and Headhunter Royal Flush is 50psi+ water pressure and volume required for the Headhunter. I have had Tecma's and they sure simplify the water requirements. I'll install a bidet in the mid-bath for now. I haven't figured out how to access the rear bath plumbing other than adding a tap on the 1' PEX, there's just not much space. I have installed taps on refrigerant lines and small plumbing lines but haven't investigated 1" taps for PEX.

[Richard]

Sharkbite will be your friend.

And put a regulator on the bidet water line to prevent water from squirting out your nose.

[hypoxia]

[Jack Houpe]

HAHAHAHA!

[hypoxia]

I couldn't find any bidets that fit on the 2012 era Headhunter Royal Flush toilet or that move under the seat.  I called Headhunter and was told there are none that fit the older units.  The later Royal Flush was redesigned to fit a normal size seat including the TOTO bidet, etc..  I have ordered a Rinse Works Aquaus 360 Handheld Bidet from Lowes and will give that a try.

[afrench]

My 14 has a Toto bidet in the half bath and master that was added. I thought it was the original toilet but maybe was changed? I’ll check tomorrow.

[hypoxia]

My 14 has a Toto bidet in the half bath and master that was added.  I thought it was the original toilet but maybe was changed? I’ll check tomorrow.

Curious if you figured that out?