You are not logged in or registered. Please login or register to use the full functionality of this board...

Author: Winegrower - Replies: 0 - Views: 2164
The Headhunter Mach5 outlet fitting cracked which required breaking open the 3/4 brass union above it.  After replacing the cracked female to male part on the Headhunter the brass union would not seat and leaked.  There being no replacement near our location I went to NAPA and picked up some valve grinding compound. I used a small vice to hold the lower half and a cordless drill motor with duck tape over the chuck to grab the upper half.  With a small amount of lapping compound between the parts