12-23-2015, 03:27 PM
As we discussed this AM. 1st Check the Sensor Connections, next take an Ohm Meter and check the Continuity of the Sensor Wire, next the manual states to check the Micro Amp to prove/disprove the Flame Sensor.
When Clarke & I discussed this it appears that the wire connection was OK so he is going to check on the Sensor. Personally I would buy a Spare Circuit Board and just install it and hope for the best (but I carry one as a spare)
When Clarke & I discussed this it appears that the wire connection was OK so he is going to check on the Sensor. Personally I would buy a Spare Circuit Board and just install it and hope for the best (but I carry one as a spare)
Steve & Patti, Bonnie and Tucker
1982 Newell 38' Classic, DD 6V92
cocktails for as many will fit in the site, dinner for as many can sit at the pick-nick table and sleeps 2 since I fixed the couch