You are not logged in or registered. Please login or register to use the full functionality of this board...


Xmas tree dash retainers
#3

Tom,
On the bottom side of my plastic dash cover there were approximately 1" round holes with a 1/2" long slot off one side. The head of the retainer is bigger than the holes but I was able to easily work them between the foam rubber and the plastic cover. The ultraleather is put on over the foam on my cover. I then pushed them sideways into the slot and they "snapped" in like they were designed. Is your dash cover not like that? Let me know if you want a photo.

"No two Newells are the same"

Steve Bare
1999 Newell 2 slide #531
Reply


Messages In This Thread
Xmas tree dash retainers - by rheavn - 12-30-2012, 04:16 PM
RE: Xmas tree dash retainers - by encantotom - 12-30-2012, 04:23 PM
RE: Xmas tree dash retainers - by rheavn - 12-30-2012, 04:37 PM
RE: Xmas tree dash retainers - by encantotom - 12-30-2012, 04:50 PM
RE: Xmas tree dash retainers - by rheavn - 12-30-2012, 05:53 PM
RE: Xmas tree dash retainers - by encantotom - 12-30-2012, 06:02 PM
RE: Xmas tree dash retainers - by Express1 - 12-31-2012, 12:36 PM
RE: Xmas tree dash retainers - by rheavn - 01-30-2013, 04:19 PM
RE: Xmas tree dash retainers - by encantotom - 01-30-2013, 05:02 PM
RE: Xmas tree dash retainers - by tuga - 01-30-2013, 05:23 PM
RE: Xmas tree dash retainers - by encantotom - 01-30-2013, 05:32 PM
RE: Xmas tree dash retainers - by tuga - 01-30-2013, 06:19 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)