03-15-2020, 11:47 AM
I have been having the same problem with my front slide, the rear bottom creeping out about 1/2" after sitting for a week or so and I will look into what Tom did to correct his issue. But I have also been having a problem with the rear bedroom slide, coming in a little to far at the top of the front while being flush at the rear. This has been causing the exterior skin to to pull loose creating a small gap about 1/8" half way along the roof of the slide. I have had it resealed three times but it still keeps happening. Today when I went to bring the bedroom slide in it seamed to be having difficulty, as if it were stuck. After trying a couple of times if finally started coming in but again as if something was stopping it so I went outside and could not see anything in the way. To get it to come in, I had to extend it a little first then retract it. After a few cycles it finally came in and at the last couple of inches it acted as if it broke loose of what was holding it back. I went back outside and could see where it looked like the bottom of the slide was rubbing against the top of the slide out opening at the center of the slide, peeling off a little paint. Any advice? Should I apply some type of lubricant to the bottom of the slide?
Thanks
Dario and Andrea Perini
#581 2001 45'8"
Thanks
Dario and Andrea Perini
#581 2001 45'8"