You are not logged in or registered. Please login or register to use the full functionality of this board...


Rear curb slide seal leak
#1

Have a leak in my rear slide right where it splices.  I turned off the regulator to stop it from continuing to air up.  Have the pressure to 1.4 psi, as low as it will go.  I can't get it fixed until April at Newell and looking for someone in the South to help.  Any recommendations?  Thank you for the help!  
Rob
2004 685

Rob Cubelo
Louisiana
2004 Newell, 47' - Current
2015 Anthem
Reply
#2

The rear driver side seal in 712 was pinched over to shorten it it was not spliced that might be repairable with out changing seal I changed my seal at a Newell gathering at a camp ground









t

John Kosir
712 2004  45-8
Reply
#3

Kris Jones, Precision Coach, Zephyr Hills, Fl.
Motor coach Store, Bradenton FL

Richard and Rhonda Entrekin
95 Newell, 390  Ex caretaker
99 Newell, 512  Ex caretaker
07 Prevost Marathon, 1025
Maverick Hybrid Toad
Inverness, FL (when we're home Cool )
Reply
#4

If you have vacuum pump installed on the seal turn the key on and let it suck the seal flat then put super glue on the leak and spray the area with accelerator immediately. It will stop the leak till you get it replaced. If you don't have vacuum plumps installed I highly recommend it. 

https://www.amazon.com/Glue-Activator-Cy...r=8-4&th=1

1999 45'  #504 "Magnolia"
Gravette, Arkansas
1996 40 XL Prevost Marathon 
Reply
#5

(8 hours ago)johnkosir Wrote:  The rear driver side seal in 712 was pinched over to shorten it it was not spliced that might be repairable with out changing seal I changed my seal at a Newell gathering at a camp ground









Thank you, I'll look into that.  

Rob Cubelo
Louisiana
2004 Newell, 47' - Current
2015 Anthem
Reply


Forum Jump:


Users browsing this thread: Trainer, 1 Guest(s)