[Richard]

The part numbers were for a DANA IFS 84. The caveat is this !!!!!!!! What I learned through this process is the brake, rotor, and hub are known as the wheel end. And the wheel end doesn’t have much to do with the suspension manufacturer at all.

I found that the same brake parts were used on Prevost. In fact, I got a lot of the later parts from Prevost. And I did a direct replacement of the entire caliper on Bill Johnson’s ride which we obtained from Prevost.

At one point in time, when rebuilding the brake systems, I was in the same place as you. Intimidated and researching for part numbers. I made very little progress, until I pulled all the wheels off one side and looked at the numbers stamped on the calipers and rotors on the coach. Then I started to make progress.