[jbr1888]

Hi everyone,

Thank you so much for all the help!  After some digging around, I ended up going with some Morimoto LED headlights.  They have worked great for me in the past and have hope these will be just as good.  Each light has a low beam and a high beam, so you can operate all four at once.  It was a little tricky to get them adjusted perfectly, but they do a great job of providing great lighting without blinding the oncoming traffic.

I know this is an old thread, but maybe you’ll see this and it would be awesome if you could share model numbers and any installation/wiring details you encountered. I’m about to change the headlights on Coach 1294.

Hello, sorry for the delayed response, I have been off grid for a bit.

Here are the headlights I choose as I used (4) of them because they offer a hi/low beam in each light thus when active I have all 4 lights at once.
Here are the lights used;  https://www.morimotohid.com/morimoto-sea...quantity=1. Select either hi beam, low beam or the hi/low beam combination which is what I picked.  I had to cut some aluminum to make a new housing for behind the fiberglass, but not too much trouble.  On the wiring make sure you remove the transformer for the xenon lights and get back to a 12 VDC wire.

Let me know if you have any questions!

Thank you for the response. That's very helpful. Do you happen to have a picture of the bracket you had to make? Or a picture of the lights once the install was complete?