10-26-2022, 04:38 PM
We did not install the new seal today, after inspecting where the track for the seal goes on the bottom we seen there was quite a bit of rust and it was not looking like it was going work to inset the new seal. We pulled the track cleaned all the old epoxy off and rust and reglued with 3m 5200, day after tomorrow we will set the new seal make the proper adjustments and put it into place. This gives me 24 hours to figure out why the bushings are screwed rather than just sit in place. I had a few pieces of billet aluminum to wait to track down in place while the 5200 cures.
1999 45' with tag axle, #504 "Magnolia"
Gravette, Arkansas